 |
 |
 |
Chiller |
|
 |
|
| A chiller
is often used to reduce heating in magnetizing fixtures, especially
in applications with fast cycle times or high-volume production. If
a fixture is overheated, the overall magnetizing performance is reduced
and it is possible that the fixture may be damaged. The chiller that
we offer is fluid-recirculating and is recommended for use with all
magnetizing fixtures that include cooling coils. |
|
 |
|
 |
|
 |
 |
Heat Rejection: 1100
Watts
Flow Rate: 4 gpm.
Flow Pressure: 100psi max.
Input Line Power: 115VAC, 60Hz, 8A max. (standard)
Fluid Line Connections: 1/4" female quick-connects
Dimensions: 14.38" W x 26.5" D x 24.25" H
(62cm x 37cm x 67 cm)
Weight: 165 lbs. |
|
 |
|
 |
 |
Magnetic
Pole Detector |
|
 |
|
| This small,
handheld device gives a light indication when a north or south magnetic
pole is held near its active location, red for north and blue for
south. It is battery operated (one 9V), and is pushbutton activated.
Sensitivity is approximately 20 gauss. |
|
 |
|
 |
|
 |
Thermocouple
Readout |
|
 |
|
 |
|
| When magnetizing
a batch of parts, it is sometimes useful to monitor the temperature
inside the magnetizing fixture. This allows the user to determine
whether the fixture is overheating or if the chiller connected to
the fixture is operating correctly. Our handheld thermocouple readout
is designed to connect to a type J thermocouple embedded in the fixture.
Temperature can be displayed in either degrees Centigrade or Fahrenheit.
Accuracy is 0.1 degree. Requires 9V battery. |
|
 |
|
 |
|
 |
Electrically
Insulating Floormats |
|
 |
|
| Our electrically
insulating floor mats protect the user during operation of the magnetizer.
All floor mats are switchboard-grade and are rated at
3,000 Volts (tested to 30,000 Volts). Available with a smooth-black
finish in two sizes: |
|
 |
|
 |
|
 |
3 ft. x 4 ft. x 1/8"
thick
(92cm x 123cm x 0.3cm)
3 ft. x 6 ft. x 1/8" thick
(92cm x 184cm x 0.3cm) |
|
 |
|
 |
|
 |
|
|
|
|
|
|